Does sblive hardware mixing even work under Solaris?

[Tomservo]

Does the hardware mixing on EMU10Kx cards on the Solaris version of the driver even work? I've sblive_devices set to 16 and vmix not loaded. Still, I can't play more than one audio stream, any other application reports the device busy.

--edit: ossinfo -a -v

Code: Select all

Audio devices
SB Audigy2 main                   /dev/oss/sblive0/pcm0  (device index 0)
    Legacy device /dev/dsp0
    Caps: DUPLEX TRIGGER
    Modes: IN/OUT
      Engine      1: Busy (OUT) by PID 869 / mplayer label 'mplayer'
SB Audigy2 front out              /dev/oss/sblive0/pcm1  (device index 1)
    Legacy device /dev/dsp1
    Caps: TRIGGER
    Modes: OUTPUT
      Out engine  1: Available for use
SB Audigy2 side out               /dev/oss/sblive0/pcm2  (device index 2)
    Legacy device /dev/dsp2
    Caps: TRIGGER
    Modes: OUTPUT
      Out engine  1: Available for use
SB Audigy2 center/lfe out         /dev/oss/sblive0/pcm3  (device index 3)
    Legacy device /dev/dsp3
    Caps: TRIGGER
    Modes: OUTPUT
      Out engine  1: Available for use
SB Audigy2 raw S/PDIF (output only)  /dev/oss/sblive0/pcm4  (device index 4)
    Legacy device /dev/dsp4
    Caps: TRIGGER
    Modes: OUTPUT
      Out engine  1: Available for use
SB Audigy2 5.1 output device      /dev/oss/sblive0/pcm5  (device index 5)
    Legacy device /dev/dsp5
    Caps: TRIGGER
    Modes: OUTPUT
      Out engine  1: Available for use

[Tomservo]

Nevermind. It's simply sblive.conf being ignored. Well, that's great.

http://www.4front-tech.com/forum/viewtopic.php?p=6478