OSS has not detected any supported sound hardware...

OSS specific BSD discussion (FreeBSD/NetBSD/OpenBSD)

Moderators: hannu, dev, cesium

Strat
New Member
Posts: 2
Joined: Sun Sep 02, 2007 4:47 pm

OSS has not detected any supported sound hardware...

Postby Strat » Sun Sep 02, 2007 4:52 pm

I am running PC-BSD 1.4 Beta in Parallels on a new Aluminum iMac. I installed OSS and everything seemed to go fine. When I run osstest it says:

OSS has not detected any supported sound hardware in your system.

When I type "ossdetect -v" i get:

Detected OSS Transparent Virtual Mixing Architecture

I have no sound. What is the problem here? Should more stuff be showing up than just the Transparent Virtual Mixing Architecture? What do I need to do? Thanks in advance.

Oko
Member
Posts: 11
Joined: Fri Aug 03, 2007 10:52 pm
Location: Arizona

Re: OSS has not detected any supported sound hardware...

Postby Oko » Thu Sep 13, 2007 8:28 am

Strat wrote:I am running PC-BSD 1.4 Beta in Parallels on a new Aluminum iMac. I installed OSS and everything seemed to go fine. When I run osstest it says:

OSS has not detected any supported sound hardware in your system.

When I type "ossdetect -v" i get:

Detected OSS Transparent Virtual Mixing Architecture

I have no sound. What is the problem here? Should more stuff be showing up than just the Transparent Virtual Mixing Architecture? What do I need to do? Thanks in advance.


PC-BSD is shipping with binaries only. You need system tree for OSS to work. You need cvsup standardsupfile or whatever. Read the handbook. You also need oss_enable="YES" in your /etc/rc.conf file.

Did you compile OSS form ports or you were using binaries form the OSS website?

You need to show as
dmesg

as well

oss-info and oss-test before

Did you read the documentatin for Open Sound System?

Strat
New Member
Posts: 2
Joined: Sun Sep 02, 2007 4:47 pm

Postby Strat » Sat Sep 15, 2007 4:54 pm

I already installed the system source. I put oss_enable="YES" in my /etc/rc.conf file. I tried installing OSS from both the website and from ports. dmesg says:

%dmesg
Copyright (c) 1992-2007 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 6.2-STABLE #50: Wed Jul 18 13:26:35 PDT 2007
root@pcbsd:/usr/obj/usr/src/sys/PCBSD-SMP
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Core(TM)2 Duo CPU T7700 @ 2.40GHz (2392.05-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0x6fa Stepping = 10
Features=0xf80b9b9<FPU>
Features2=0x1<SSE3>
real memory = 1073741824 (1024 MB)
avail memory = 1041555456 (993 MB)
kbd1 at kbdmux0
ath_hal: 0.9.20.3 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
cpu0 on motherboard
pcib0: <Intel> pcibus 0 on motherboard
pir0: <PCI> on motherboard
pci0: <PCI> on pcib0
pci0: <display> at device 2.0 (no driver attached)
pci0: <bridge> at device 3.0 (no driver attached)
ed0: <RealTek> port 0x4c00-0x4c1f irq 10 at device 5.0 on pci0
ed0: Ethernet address: 00:1c:42:68:c6:ed
ed0: type RTL8029 (16 bit)
agp0: <Intel> mem 0xe0000000-0xe3ffffff at device 30.0 on pci0
isab0: <PCI> at device 31.0 on pci0
isa0: <ISA> on isab0
atapci0: <Intel> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0x5000-0x500f at device 31.1 on pci0
ata0: <ATA> on atapci0
ata1: <ATA> on atapci0
pmtimer0 on isa0
orm0: <ISA> at iomem 0xc0000-0xc9fff on isa0
atkbdc0: <Keyboard> at port 0x60,0x64 on isa0
atkbd0: <AT> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
psm0: <PS> flags 0x1000 irq 12 on atkbdc0
psm0: [GIANT-LOCKED]
psm0: model IntelliMouse Explorer, device ID 4
ppc0: parallel port not found.
sc0: <System> at flags 0x100 on isa0
sc0: VGA <16>
sio0: configured irq 4 not in bitmap of probed irqs 0
sio0: port may not be enabled
sio0 at port 0x3f8-0x3ff irq 4 flags 0x10 on isa0
sio0: type 8250 or not responding
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
Timecounter "TSC" frequency 2392047864 Hz quality 800
Timecounters tick every 1.000 msec
ad0: 10000MB <Virtual> at ata0-master UDMA100
acd0: DVDR <PRL> at ata0-slave PIO4
acd0: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00
acd0: FAILURE - INQUIRY ILLEGAL REQUEST asc=0x24 ascq=0x00
cd0 at ata0 bus 0 target 1 lun 0
cd0: <MATSHITA> Removable CD-ROM SCSI-0 device
cd0: 16.000MB/s transfers
cd0: Attempt to query device size failed: NOT READY, Medium not present
Trying to mount root from ufs:/dev/ad0s1a
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
ppc0: parallel port not found.
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
logo_saver: the console does not support M_VGA_CG320
module_register_init: MOD_LOAD (logo_saver, 0xc51a59f8, 0) error 19
%

Oko
Member
Posts: 11
Joined: Fri Aug 03, 2007 10:52 pm
Location: Arizona

Postby Oko » Wed Sep 19, 2007 2:34 am

Do you have idiotic RealTek Sound Card?
OSS is not going to help you but hnd driver from Ariff might if you know what are you doing.


Return to “BSD”

Who is online

Users browsing this forum: Bing [Bot] and 1 guest