Trouble shooting for 4 hours & no luck. Hope this is something minor like mixer setting. Thx in advance ... Here are my outputs...
Code: Select all
dome# dmesg
Copyright (c) 1992-2007 The FreeBSD Project.
Copyright (c) 1979, 1980, 1983, 1986, 1988, 1989, 1991, 1992, 1993, 1994
The Regents of the University of California. All rights reserved.
FreeBSD is a registered trademark of The FreeBSD Foundation.
FreeBSD 6.2-RELEASE #9: Sat Sep 15 15:37:51 EDT 2007
root@dome.home.com:/usr/obj/usr/src/sys/DOME
Timecounter "i8254" frequency 1193182 Hz quality 0
CPU: Intel(R) Pentium(R) 4 CPU 2.00GHz (1999.79-MHz 686-class CPU)
Origin = "GenuineIntel" Id = 0xf27 Stepping = 7
Features=0xbfebfbff<FPU>
Features2=0x4400<CNTX-ID,<b14>>
real memory = 1878917120 (1791 MB)
avail memory = 1828315136 (1743 MB)
ACPI APIC Table: <IBM>
MADT: Forcing active-low polarity and level trigger for SCI
ioapic0 <Version> irqs 0-15 on motherboard
ioapic1 <Version> irqs 16-31 on motherboard
ioapic2 <Version> irqs 32-47 on motherboard
kbd1 at kbdmux0
ath_hal: 0.9.17.2 (AR5210, AR5211, AR5212, RF5111, RF5112, RF2413, RF5413)
acpi0: <IBM> on motherboard
acpi0: Power Button (fixed)
unknown: I/O range not supported
unknown: I/O range not supported
Timecounter "ACPI-fast" frequency 3579545 Hz quality 1000
acpi_timer0: <32> port 0x40c-0x40f on acpi0
cpu0: <ACPI> on acpi0
pcib0: <ACPI> on acpi0
pci0: <ACPI> on pcib0
pci0: <display> at device 3.0 (no driver attached)
isab0: <PCI> at device 15.0 on pci0
isa0: <ISA> on isab0
atapci0: <ServerWorks> port 0x1f0-0x1f7,0x3f6,0x170-0x177,0x376,0x3400-0x340f at device 15.1 on pci0
ata0: <ATA> on atapci0
ata1: <ATA> on atapci0
ohci0: <OHCI> mem 0xeddff000-0xeddfffff irq 10 at device 15.2 on pci0
ohci0: [GIANT-LOCKED]
usb0: OHCI version 1.0, legacy support
usb0: <OHCI> on ohci0
usb0: USB revision 1.0
uhub0: (0x1166) OHCI root hub, class 9/0, rev 1.00/1.00, addr 1
uhub0: 2 ports with 2 removable, self powered
pcib1: <ACPI> on acpi0
pci1: <ACPI> on pcib1
pci1: <multimedia> at device 2.0 (no driver attached)
pcib2: <ACPI> on acpi0
pci2: <ACPI> on pcib2
bge0: <Broadcom> mem 0xed4f0000-0xed4fffff irq 22 at device 4.0 on pci2
miibus0: <MII> on bge0
brgphy0: <BCM5703> on miibus0
brgphy1: 10baseT, 10baseT-FDX, 100baseTX, 100baseTX-FDX, 1000baseTX, 1000baseTX-FDX, auto
bge1: Ethernet address: 00:02:55:b7:9a:d8
acpi_button0: <Power> on acpi0
fdc0: <floppy> port 0x3f0-0x3f5,0x3f7 irq 6 drq 2 on acpi0
fdc0: [FAST]
fd0: <1440-KB 3.5" drive> on fdc0 drive 0
atkbdc0: <Keyboard> port 0x60,0x64 irq 1 on acpi0
atkbd0: <AT> irq 1 on atkbdc0
kbd0 at atkbd0
atkbd0: [GIANT-LOCKED]
sio0: <16550A> port 0x3f8-0x3ff irq 4 flags 0x10 on acpi0
sio0: type 16550A, console
pmtimer0 on isa0
orm0: <ISA> at iomem 0xc0000-0xc7fff on isa0
ppc0: parallel port not found.
sc0: <System> at flags 0x100 on isa0
sc0: VGA <16>
sio1: configured irq 3 not in bitmap of probed irqs 0
sio1: port may not be enabled
vga0: <Generic> at port 0x3c0-0x3df iomem 0xa0000-0xbffff on isa0
ucom0: FTDI USB <-> Serial, rev 1.10/2.00, addr 2
Timecounter "TSC" frequency 1999792736 Hz quality 800
Timecounters tick every 1.000 msec
ipfw2 (+ipv6) initialized, divert loadable, rule-based forwarding enabled, default to deny, logging limited to 100 packets/entry by default
ad0: 38162MB <IC35L060AVV207> at ata0-master UDMA100
acd0: CDROM <LG> at ata0-slave UDMA33
ad2: 114473MB <WDC> at ata1-master UDMA100
Trying to mount root from ufs:/dev/ad0s1a
audigyls0: <AudigyLS> port 0x5000-0x501f irq 18 at device 2.0 on pci1
dome# ossinfo
Version info: OSS 4.0 (b070831/200709152030) (0x00040002) CDDL
Platform: FreeBSD/i386 6.2-RELEASE FreeBSD 6.2-RELEASE #9: Sat Sep 15 15:37:51 EDT 2007 root@dome.home.com:/usr/obj/usr/src/sys/DOME (dome.home.com)
Number of audio devices: 9
Number of audio engines: 9
Number of MIDI devices: 0
Number of mixer devices: 1
Device objects
0: audigyls0 AudigyLS
1: vmix0 OSS transparent virtual support
MIDI devices (/dev/midi*)
Mixer devices (/dev/mixer*)
0: AudigyLS Mixer (Mixer 0 of device object 0)
Audio devices
/dev/oss/audigyls0/pcm0 AudigyLS front (device index 0)
/dev/oss/audigyls0/pcm1 AudigyLS (shadow) (device index 1)
/dev/oss/audigyls0/pcm2 AudigyLS center/lfe (device index 2)
/dev/oss/audigyls0/pcm3 AudigyLS surround (device index 3)
/dev/oss/audigyls0/pcm4 AudigyLS 5.1 output (device index 4)
/dev/oss/vmix0/pcm0 AudigyLS front (VMIX0) (device index 5)
/dev/oss/vmix0/pcm1 AudigyLS front (VMIX0) (device index 6)
/dev/oss/vmix0/pcm2 AudigyLS front (VMIX0) (device index 7)
/dev/oss/vmix0/pcm3 AudigyLS front (VMIX0) (device index 8)
pciconf -lv
audigyls0@pci1:2:0: class=0x040100 card=0x100a1102 chip=0x00071102 rev=0x00 hdr=0x00
vendor = 'Creative Labs'
device = 'CA0106-DAT Audigy LS'
class = multimedia
subclass = audio
dome# osstest
Sound subsystem and version: OSS 4.0 (b070831/200709152030) (0x00040002)
Platform: FreeBSD/i386 6.2-RELEASE FreeBSD 6.2-RELEASE #9: Sat Sep 15 15:37:51 EDT 2007 root@dome.home.com:/usr/obj/usr/src/sys/DOME
*** Scanning sound adapter #-1 ***
/dev/oss/audigyls0/pcm0 (audio engine 0): AudigyLS front
- Performing audio playback test...
<left> OK <right> OK <stereo> OK <measured>
/dev/oss/audigyls0/pcm1 (audio engine 1): AudigyLS (shadow)
- Skipping device (card already tested)
/dev/oss/audigyls0/pcm2 (audio engine 2): AudigyLS center/lfe
- Performing audio playback test...
<left> OK <right> OK <stereo> OK <measured>
/dev/oss/audigyls0/pcm3 (audio engine 3): AudigyLS surround
- Performing audio playback test...
<left> OK <right> OK <stereo> OK <measured>
/dev/oss/audigyls0/pcm4 (audio engine 4): AudigyLS 5.1 output
- Skipping multi channel device
*** Scanning sound adapter #0 ***
/dev/oss/vmix0/pcm0 (audio engine 5): AudigyLS front (VMIX0)
- Skipping virtual device (use -V to force test)
*** Scanning sound adapter #0 ***
/dev/oss/vmix0/pcm1 (audio engine 6): AudigyLS front (VMIX0)
- Skipping virtual device (use -V to force test)
*** Scanning sound adapter #0 ***
/dev/oss/vmix0/pcm2 (audio engine 7): AudigyLS front (VMIX0)
- Skipping virtual device (use -V to force test)
*** Scanning sound adapter #0 ***
/dev/oss/vmix0/pcm3 (audio engine 8): AudigyLS front (VMIX0)
- Skipping virtual device (use -V to force test)
dome# ossmix
Selected mixer 0/AudigyLS Mixer
Known controls are:
ext.spread ON|OFF (currently ON)
ext.loopback ON|OFF (currently OFF)
ext.recordvol <monovol> (currently 128)
ext.recordsrc <MIC> (currently MIC)
vmix0-src <Fast> (currently Fast)
vmix0-vol <monovol> (currently 25.0 dB)
vmix0-out <leftVU>:<rightVU>] (currently 0:0)
vmix0-out.pcm5 <both>[:<rightvol>] (currently 25.0:25.0 dB)
vmix0-out <leftVU>:<rightVU>] (currently 0:0)
vmix0-out.pcm6 <both>[:<rightvol>] (currently 25.0:25.0 dB)
vmix0-out <leftVU>:<rightVU>] (currently 0:0)
vmix0-out.pcm7 <both>[:<rightvol>] (currently 25.0:25.0 dB)
vmix0-out <leftVU>:<rightVU>] (currently 0:0)
vmix0-out.pcm8 <both>[:<rightvol>] (currently 25.0:25.0 dB)
vmix0-out <leftVU>:<rightVU>] (currently 0:0)
vmix0-in <leftVU>:<rightVU>] (currently 0:0)
dome# cat /dev/sndstat
OSS 4.0 (b070831/200709152030) CDDL (C) 4Front Technologies 1996-2007
Kernel: FreeBSD 6.2-RELEASE #9: Sat Sep 15 15:37:51 EDT 2007
root@dome.home.com:/usr/obj/usr/src/sys/DOME
Audio devices:
0: AudigyLS front (DUPLEX)
1: AudigyLS (shadow) (DUPLEX)
2: AudigyLS center/lfe (OUTPUT)
3: AudigyLS surround (OUTPUT)
4: AudigyLS 5.1 output (OUTPUT)
5: AudigyLS front (VMIX0) (DUPLEX)
6: AudigyLS front (VMIX0) (DUPLEX)
7: AudigyLS front (VMIX0) (DUPLEX)
8: AudigyLS front (VMIX0) (DUPLEX)
Mixers:
0: AudigyLS Mixer
History:
/dev/oss/audigyls0/pcm2.02: pid 1084 cmd 'osstest' OUT
/dev/oss/audigyls0/pcm3.03: pid 1084 cmd 'osstest' OUT
/dev/oss/audigyls0/pcm0.00: pid 1752 cmd 'osstest' OUT
/dev/oss/audigyls0/pcm2.02: pid 1752 cmd 'osstest' OUT
/dev/oss/audigyls0/pcm3.03: pid 1752 cmd 'osstest' OUT
NOTICE! This /dev/sndstat file is obsolete - use the ossinfo command instead
*** All tests completed OK ***